Jump to content
muz123

265-6 transmission slips

Recommended Posts

muz123

Just picked up a 265-6 and it runs great except the tranny will slip while going uphill, so there will be some jerky motion, then run fine for a while. Otherwise it goes great. Any ideas that don't include swapping out the tranny?

Thanks!

Share this post


Link to post
Share on other sites
 
Sparky

I'm not familiar with your particular tractor but I suspect that the belt is stretched or the wrong size (to big) or a tension spring is shot or missing. There are no clutches in your 6 speed tranny to slip. Its either in gear or its not.

Mike.....

Share this post


Link to post
Share on other sites
 
gwest_ca

Possibly the drive belt is slipping? Here is the service manual

 

 

Garry

  • Like 1

Share this post


Link to post
Share on other sites
 
muz123

Thanks, I'll check the belt tomorrow.

Muz

Share this post


Link to post
Share on other sites
 
Fluffy3

Late I know but I thought I would post for future people searching the forums for answers. So the 265-6 with peerless 820-24 is a great transaxle but has weak shift keys. If it starts to jerk under a load the shift keys are worn they will slip in the gear grab and slip causing the jerks. Split case replace shift keys a easy job. Here is the superceded part # from peerless. Hope this helps.

 

799012  = Replaces 792138, 792123, 792123A Shift Keys

  • Like 1

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...