Tom. 70 #1 Posted February 22, 2014 Hi all, I can't seem to find what the bolt sizes are for the side of the engine? The ones on the pulley side. I need to get some bolts to hold some "tabs" that will keep the belt in place. Hope that makes sense! Tom Share this post Link to post Share on other sites
meadowfield 2,758 #2 Posted February 22, 2014 On k241 and above they are 3/8 unc if I recall... I would think the same on yours. Share this post Link to post Share on other sites
Tom. 70 #3 Posted February 22, 2014 Hi Mark, I tried some bolts out of a K181 a few backs I think(bad memory!!) and they didn't fit, I will try the ones on my k321 in there and try the k181 ones again just to make sure. Thanks, Tom Share this post Link to post Share on other sites
stevasaurus 23,303 #4 Posted February 22, 2014 try this link...it gives the bolt sizes for each group below the diagram...maybe this is what you need??? Share this post Link to post Share on other sites
Tom. 70 #5 Posted February 22, 2014 Hi Steve, Thank you for the link however I'm pretty sure it doesn't show the bolts on the side, I've looked all over but just can't seem to find them! Tom Share this post Link to post Share on other sites
buckrancher 2,695 #6 Posted February 23, 2014 5/16-24 Share this post Link to post Share on other sites
Tom. 70 #7 Posted February 23, 2014 Perfect, thank you very much! Tom Share this post Link to post Share on other sites
