Fishroe 261 #1 Posted December 7, 2013 Can anyone tell me where the brake pedal safety switch is suppose to go. I'm rewiring the tractor and have discovered the brake switch is missing. No idea what it looks like. the only place it looks like it could go is by the locking lever. not sure what switch it is looking at electrical diagram. thanks Share this post Link to post Share on other sites
WH nut 553 #2 Posted December 8, 2013 Check back by the belt idler pulley Share this post Link to post Share on other sites
Fishroe 261 #3 Posted December 8, 2013 (edited) i have that one on the idler pulley thats the clutch pedal switch the circuit board has a light for parking brake. the wiring diagram also shows parking brake switch but somebody has taken it off. i traced the wire back from the circuit board. it goes to a connector with 2 wires going out. one of the wires going out is missing, that's probably the one that goes to the missing switch. Edited December 8, 2013 by Fishroe Share this post Link to post Share on other sites
buckrancher 2,694 #4 Posted December 8, 2013 (edited) the switch mounts to the bottom side of the gear shift pattern plate in front of the seat brian Edited December 8, 2013 by buckrancher Share this post Link to post Share on other sites
Fishroe 261 #5 Posted December 8, 2013 thanks man just looked and its there. i've had that plate off sitting to the side forabout 10 days. neve even thought about looking at that. what a dummy. i'd be lost without you guys. have a good evening Share this post Link to post Share on other sites
