mad welder 0 #1 Posted October 13, 2013 I just got a plow for my WH when i got it home i found that the though the years it had been ground down half way though the support rib at the bottom could someone send me a photo of how long that portion of the blade is so i can repair it. thanks Mad welder Share this post Link to post Share on other sites
daveoman1966 3,841 #2 Posted October 14, 2013 The 1st pic here is of the wear edge of the dozer blade, taken from the back side, upside-down. This would be then, the lower right corner of the back of the dozer blade This one isn't worm much at all, although it is kinda rusty. There is probably 3/8" of material of the wear edge exposed here and this is what it ought to look like, from the back side..of course. The 2nd pic is the wear bar bolted to the dozer blade. Share this post Link to post Share on other sites
SousaKerry 503 #3 Posted October 14, 2013 I wouldn't bother welding one, probobly cost more in wire then to just buy a new 3/8" x 2" piece of steel bar. Drill a few holes and ya got one better then new. Also you can flip them over if not too badly worn. Share this post Link to post Share on other sites
mad welder 0 #4 Posted October 14, 2013 (edited) I want to repair the blade backing. Daveoman 1966's photos were a great help thanks to all! Edited October 14, 2013 by mad welder Share this post Link to post Share on other sites
