48" s/d deck spindle bearing part numbers what are they

[wheelhorsec85 5]

i have a 48" s/d attach a matic deck the spindles have 3/4" sharts and also greese fittings in the top what is the part number for the bearings 

[gwest_ca-(File Mod) 11,499]

You should find the answer in this file

Helps if you know the model number of your deck.

 

Garry

[gwest_ca-(File Mod) 11,499]

Toro bearing 106084 I believe is a 6203-RS 3/4" with no seals for the bottom. OD is 40mm, ID is 3/4"

Toro bearing 106085 I believe is a 6203-3/4" with one seal for the top. OD is 40mm, ID is 3/4"

 

Toro bearing 109966 is a 6203 but don't know how many seals. OD is 40mm, ID is 17mm.

 

These are very popular bearings and often cheaper with the 2 seals. Just stick an awl into a seal and pop it out if you don't need it. For the grease to get into the bearing at least one seal on each bearing must be removed.

 

Garry

[Tankman 3,523]

Another place to take a peek-a-boo http://www.partstree.com/parts/?lc=Toro+Consumer&mn=E5-48SC01

 

Good luck.

[daveoman1966 3,841]

Garry has identified the bearings and I have three sets of NEW bearings # 106084 (no seal) and 106085 (sealed 1 side).  Will sell them for $20 per set of two or $50 for all three sets. 

Ship charges will be $5 to USA zips for any quantity.

Here is a pic...new in unopened plastic bags.  

 

Dave in n/w PA at zip 16433

Edited September 4, 2013 by daveoman1966