partin_us_99 0 #1 Posted September 2, 2013 So I got a gt2500 with plow to do some plowing this winter as well as scrape off top layer of crud on my driveway. Ive been working on it for bout a month or two ive rebuilt the carb replaced the float needle new gaskets etc. Put it back on the tractor and still no start. It acted like it was gonna start and run a lil bit couple days ago but I ran out of gas. Long story short no start plug has good spark but its as if its not even getting fuel. Plug isnt wet at all. I need a linkage diagram for this tractor bc I found a spring just sitting on the frame and I dont think any of linkages are hooked up right. Its a briggs engine. Sent from my SAMSUNG-SGH-I317 using Tapatalk 2 Also its dripping gas from what looks to be a vent hole on the bottom of the carb? Never seen that before Sent from my SAMSUNG-SGH-I317 using Tapatalk 2 Share this post Link to post Share on other sites
