It's a small world... really it is

[cruisnblue48 783]

Latest update pics on my dad's 552 tractor...

 

 

 

 

Obviously did not get er done by July... but then again, if I had gotten it done already, there wouldn't be more to do, ha. Still coming along nicely.

 

[Retired Wrencher 4,877]

    Very nice Job I say thank God that there is over 11000 people here that are saving these fine tractors, Gary   B,,,,

[boovuc 1,090]

Very nice! Excellent Restore!

[Patrick Reese 40]

Great looking tractor. Waiting in anticipation for more pics and the final results!

 

Can you tell us a little more about the engine (B&S) that was on it with the gas tank poking out the hole in the grill and what you did to remedy it?

Edited September 22, 2013 by Patrick Reese

[876wheelhorse 46]

why do people act like that he said he took it to a cub cadet dealer they wouldnt touch it cause its a wheelhorse

[Elkskin's mower junkyard 1,117]

On 9/22/2013 at 11:43 PM, 876wheelhorse said:

why do people act like that he said he took it to a cub cadet dealer they wouldnt touch it cause its a wheelhorse

yes but most shops will look at it atleast around here and give you an idea of how to take it apart. 

[Rob.A.700 306]

Great story! As for the cubcadet shop some places are finicky about stuff like that. If it gets damaged by there hand more often now a days the customer is less understanding.

[Wheel-N-It 2,967]

For those of you reading this thread now that it is active again;

Do Not Under Any Circumstances Hammer On The End Of The Lift Lever Shaft. The steel is very soft and will mushroom faster than you can say Wheel Horse. If PB Blaster does not penetrate, go to your local Chevy Dealer and buy a can of GM penetrant. That stuff goes where PB Blaster cannot. Once the two sections start twisting just keep spraying the penetrant. It will come apart, just be patient.