rj35 aluminum steering wheel question

[ricksrj58 273]

i have a repro steering wheel and need to know where to drill my hole for the roll pin,what size also.thanks

[clintonnut 126]

If you have a steady hand, position a marker directly over the hole in the steering wheel, slide the wheel on, mark a dot and drill a hole. You will have to use a bit to gauge the size in the shaft. Once you drill through one side, keep it aligned and drill through the other side. The hole already existing in the shaft will be a pilot hole as you drill, keeping the bit aligned.

Worked for me!

Charlie

[VinsRJ 723]

Size would be 3/16" roll pin.