Pilot101 2 #1 Posted January 26, 2013 Ok everyone, I am down to needing just a few more things and am having a lot of trouble with two parts. First I am looking for a part number or the correct throttle speed control assy for this it has a H60-75267G tecumseh. Also I need the pull starter cup. The ones I have found are too small in diameter and will not let the pull starter assy set into it. And last but not least the tie rod part # 3605. Any help on part numbers, where to get them, or if you have them would be greatly appreciated. Share this post Link to post Share on other sites
KC9KAS 4,744 #2 Posted January 26, 2013 Nice looking WH, and in case I haven't said it earlier, :WRS: Share this post Link to post Share on other sites
redhorse47 0 #3 Posted January 27, 2013 You need a pull starter off of a Lauson- techumseh H55 which is an aluminum casting approx. 7 inches dia. There also is a steel mounting ring with 1/4-20 studs which come from the inside of the cover outward and the starter is held on with nuts and lockwashers. Original tin has eight holes so the rope can be positioned at different angles. Ithink you can use your cover but you might have to drill some holes. Also ,the cup is larger in diameter and has very prominent teeth on the i.d. Items you need are not that hard to find as yet. Also, correct engine decals are available from Joe Papke and others. Good tie-rods are available but you might need to repair yours by staking the edges of the pivot ball holes with a small blunt punch until you can find a good one. Nice tractor. Good luck. Share this post Link to post Share on other sites
Callen 64 #4 Posted January 27, 2013 Can you post a pic of the recoil starter that you are using? Share this post Link to post Share on other sites
