making a mid mount grader ?

[oneroadkingman 53]

hello guys, i was concerding of making one out of a old front mount 42 in snow blade that i had laying around thoughts?.was going to cut the long frame down to fit under the center while attaching to the rear end.also using the part that pivoits and cutting the blade down to 12" to fit under frame .has any one ever done this before.might be biting off mor than i can chew lol. thanks

[Hydro 130]

check out the earlier post on mid mount grader blade, it right below your new post it's April 22 or there abouts

[sorekiwi 761]

A few years ago there were a couple of documented builds of grader blades by members here:

http://www.wheelhors...age__hl__grader

http://www.wheelhors...__fromsearch__1

http://www.wheelhors...__fromsearch__1

http://www.wheelhors...__fromsearch__1

http://www.wheelhors...__fromsearch__1

[oneroadkingman 53]

thanks for the direction it will give some reading material for the week end lol.

[AMC RULES 36,957]

If you do decide to give it a whirl...

[Hydro 130]

I have a rear axle mount W/H grader blade and were I to do it over I would prefer to have the front mount and drag rather than push the blade. :twocents-02cents:

[tomtractor 71]

Thanks. I will get creative.