WHEEL HORSE BILL 7 #2 Posted February 6, 2012 Very nice lookin but is that loader frame even strong enough to pick things up with all the holes in it. Share this post Link to post Share on other sites
nowife69 4 #3 Posted February 6, 2012 you tell me and this is not air brushed..lol easy 1000 lbs...chevy 350 engine, rocks, trees, oh and lifted one end of this to drag it out of woods. Share this post Link to post Share on other sites
nowife69 4 #4 Posted February 6, 2012 bolens large front end, simplicity steering box, ford 145 rear end, 18 hp briggs with jack shaft and 90 degree gear box to shaft rear end, steel was junk..they hold up 30 foot satilite dishes...., 18 gpm pump, 2 inch bore cylinders, Share this post Link to post Share on other sites
AMC RULES 36,957 #5 Posted February 6, 2012 Looks beastly for sure. Share this post Link to post Share on other sites
nowife69 4 #6 Posted February 6, 2012 thank you.....pretty doesnt get the job done.....ive done everything i could throw at it, with in reason . but did lift the back of my 2003 durango off the ground about 6 inches....lol whats nice too is it can dig about 9 inches down past the front wheels. and has about 7 feet of lift clearance. Share this post Link to post Share on other sites
AMC RULES 36,957 #7 Posted February 6, 2012 Did you build it? Share this post Link to post Share on other sites
nowife69 4 #8 Posted February 6, 2012 yes i did....lots of mistakes but did it piece by piece.....no real planning....i did get the loader plans from PF engineering, but had to modify for my needs.....including the heat sink from a large car amp.... dial electric epoxy to glue it on to the hydraulic tank...lol Share this post Link to post Share on other sites
Jake Kuhn 1,547 #9 Posted February 6, 2012 Now thats a beast! Share this post Link to post Share on other sites
squonk 39,054 #10 Posted February 7, 2012 18 GPM? Holy Snikees! My Power King loader pump is only 6 GPM! Share this post Link to post Share on other sites
nowife69 4 #11 Posted February 8, 2012 lol, its fast , you just got to keep it slow....lol i went way overboard on all the hydraulics, but didnt want to have to upgrade...i can always turn down the power at the valve Share this post Link to post Share on other sites
