how to inspect breaker on 16HP Kohler ( k341)

[rodcogroup 3]

I have a C-161 with the K341 engine. I am cleaning things up on the engine ( tightning screws, cleaning off oil etc). I noticed that the points ( breaker) on the engine does not have a cover. Is this that important?

I took the breaker off, cleaned it up and it looks ok, but I am not sure if it is worn out or not. Do I need to replace the breaker rod if I replace the breaker?

Here are some photos:

http://farm8.staticf...5b971e7ef_b.jpg

http://farm8.staticf...fc3d37df2_b.jpg

http://farm8.staticf...231639c8d_b.jpg

Thanks

Robert

[WH854 44]

Yes there is a cover over the points click on this there is a pictureof one.

http://gardentractorpullingtips.com/ignition.htm#timing

Welcome to Red Square

Chas

[Sparky-(Admin) 22,242]

I noticed that the points ( breaker) on the engine does not have a cover. Is this that important?

I

Thanks

Robert

Sure is. It should have a cover and a gasket to keep moisture out and the spark it creates in. Remember right above the points is a rubber hose and a carb and a fuel pump full of gas and gasoline and sparks don't mix well outside the engine.

Mike...........

[gregg'shorses 77]

Joe's outdoor power on ebay usually has them.

[refracman 167]

Robert,

As stated above yes you need the cover & gasket. Yes replace the points( breakers) and no you don't need to replace the rod.

When you go to local small engine shop to pick up the points they should have a used cover, gasket and screws. The new points are set between 16 and 20 on your feeler gauge, if you dont have a set, any car parts place will have them.

You can download a manual free from Kohler for your engine at there web site, make sure to login as a visitor.