PTO and drive pulley removal on C-111

[Will G 3]

Can someone provide me insight on how to remove the PTO assembly and drive pulley on a 1979 C-111?

[rmaynard 14,934]

Once the PTO housing rod (the curved rod) and the PTO brake has been removed, the PTO bell should slide off. Remove the 4 screws that hold the retainers in place, remove the retainers, and slide the bearing race off the crankshaft. Remove the clutch plate. There are 2 setscrews in the pulley. Loosen or remove them, and using an appropriate gear puller, remove the drive pulley.

Though the C-111 is not specifically covered, the PTO removal procedure is in the B,C,D service manual.

http://www.mywheelhorse.com/graphics/file/...al_810063Rl.pdf

[Will G 3]

Thank you