Assembly manual need for front plow

[Butch 194]

I'm putting my snow plow together that's been laying around 5 years and can't figure out where a heavy wire goes. There are 2 of them. One goes to the pin to release the plow for turning and the other has about a 5" bar/rod at the end that I can't figure out where it goes. Can anyone help me. I could take a picture if needed. Thanks.

[rmaynard 14,945]

Are you sure on that number (641136), or could it be a 6-4113 6?

http://www.mywheelhorse.com/graphics/file/...rame_6-4113.pdf

[Butch 194]

Are you sure on that number (641136), or could it be a 6-4113 6?

http://www.mywheelhorse.com/graphics/file/...rame_6-4113.pdf

Bob the part number was like this 6-4113-6. The manual you gave me was the correct one.

But it doesn't show me where part number 26 goes, the assembly lever.

Thanks for the manual!

[rmaynard 14,945]

Waiting for RedSquare tonight is like watching paint dry. By the time I get to post this, you will have figured it out.

Anyway, part #26 is attached just about 4 inches below the top of lever #23. If you look, you will see a hole.

[Butch 194]

Thanks again Bob! Does itgo on the front side or back side? Thanks again

[rmaynard 14,945]

You want to mount it so that when you grip the lever, you are pulling it toward you. So I guess that means that it mounts on the front side of the arm.

I can take a picture of mine if you need it.

[Butch 194]

Got it. Thanks!