Lane Ranger 11,419 #1 Posted August 5, 2011 Somone named Ed sent me a personal note on Red Square email but did not give me his email for response. Here were the questions: sorry to bother you again started work on my tractors and could use some help. do you have part #s and a source for the wheel seals front rims and tha source for brushes for the gen /starter. i just had anothe look at your 1054s they are real neat. also do you have a source for a grill mesh thanking you in advance for your time ed *** SKF (old Chicago Rawhide site) says the 3373 bearing seal in the front wheels of the 953/1054 is a 10035. I have not changed one so I can not say this is the correct number but the SKF/Chicago Rawhide site has always had the correct wheel horse part number in the past for me. 3373 WHEELHORSE 10035 The starter/generator brushes can be purchased on Ebay very reasonably and work well on the Delco starter/generators. I have repalced two sets. As far as the grill for the 1054 that is a difficult issue. There are several differnt stamped metals used . The measurements are 12 1/4 inches at the top, 12 inches on eaach side and 10 1/4 along the bottom for any metal sheets used. :woohoo: Share this post Link to post Share on other sites
Martin 2,133 #2 Posted August 5, 2011 lane, from what i remember the seal number from skf is the correct one. Share this post Link to post Share on other sites
JimD 3,347 #3 Posted August 5, 2011 No way to respond to Red Square email You can respond to his email through his profile by clicking on the email link in the communication section. :woohoo: Share this post Link to post Share on other sites
Lane Ranger 11,419 #4 Posted August 5, 2011 Jim: If I knew Ed's profile I could! My note was just signed ED! :woohoo: Share this post Link to post Share on other sites
rmaynard 16,346 #5 Posted August 5, 2011 Someone named Ed sent me a personal note on Red Square email but did not give me his email for response. I don't know what type of email server you are using, but I use Outlook Express. In Outlook Express, where it says FROM in the heading, it will say RedSquare. Double-click on RedSquare and it will show you his direct email address. Share this post Link to post Share on other sites
Lane Ranger 11,419 #6 Posted August 5, 2011 Jim and Bob: I got it finally -how to email Ed and I think you! I guess you can tech an old dog new tricks. I have been hitting the wrong link! :woohoo: Share this post Link to post Share on other sites
.thumb.JPG.1b2a1a39cdcedb1e001571713350b32c.JPG)