C- 101 8-SPEED STEERING SHAFT

[dmoore 1,022]

Well after experiencing steering wheel wobble for years I finally decided to do some thing about it...I ordered a new steering shaft (20.5" long,3/4 diameter)from Mowparts.com,#92-4987....I noticed another roll pin hole drilled 7 3/4" down from the steering wheel roll pin and at 180 degrees apart....anyone know what it is for?

Anyhow, I noticed the teeth on my original 33 year old shaft were worn sharp and looked to be rolled over viewed from the side causing a lot of play down at the sector gear(lower steering shaft). I'll prime and paint it tomorrow & put her back together this weekend. I had replaced the original steering wheel back in 96 when I restored the tractor....didn't notice any play back then..must have been the 10 years of use that followed.

I can't remember who tipped me off to www.mowparts.com but thank you! What a difference in price! Although I'm sure if it was bought directly from Toro it would have come painted....no biggie!

[rmaynard 16,700]

They don't come painted from Toro either. Mowpart gets these directly from Toro. I have been using Mowpart.com long before I was a member of RedSquare. They are always cheaper. That is why I always recommend them to anyone looking to buy Toro parts online.

[dmoore 1,022]

Bob, It may have been you that mentioned them.....if so thank you! Now what about www.sepw.com? I think they hail out of Wisconsin.......Dave