Wheel horse pulling tractors?????

[wheelhorsenut69 0]

Alright now to see who thinks what in this site in everyones opinion what is the most power full type pulling tractor the c160 manual tranny 4speed or 8 or the c160 hydro everyone around mn thinks the hydros pull harder????? i dont see it i would think the gear shifts would take it and be tougher???? also is there any diffrence in the c161 trannys to the c 160 if so witch is better i was looking for feed back from the the other horse nuts here> :wh:

[TT-(Moderator) 1,169]

Use a gear-drive tranz for pulling - preferably an 8 speed with the 8 pinion differential.

The parasitic loss and relief valves in the hydro units make them virtually worthless at competitive pulling in their stock form.

For the sake of this discussion, C-160 & C-161 models use the same transaxles.

[Raider12puller 1]

Definitely use the 8 speed transaxle both of those tractors should have the 8 pinion in them if they havent had the transaxles changed.

[baerpath 517]

A freind tried using a C195 with 26 12 12 tires for pulling What a joke the 12hp gear drives could pull the sled farther. Wasn't anything wrong with his hydro either I still have it

Duane

[AMC RULES 37,251]

So what are hydros good for? What makes them so attractive?

[baerpath 517]

mowing and snowblowing

Where you change speed and direction alot

[C-Series14 15]

X2... :thumbs:

[can whlvr 994]

i like mine for tilling too,you can choose just the right speed,its also a bonus for the hydro lift,a real bonus for all the attachments,especially the dozer plow