KB9LOR 4 #1 Posted March 6, 2011 I have a deck off my old 68 Raider 12 that needs 1 upper bearing in the spindle, this deck has the steel housings, not the cast ones, the deck has no markings on it other than the height and caution stickers, the original part # on the upper bearing is "nice 7330 Made in USA...any help here? Share this post Link to post Share on other sites
KB9LOR 4 #2 Posted March 6, 2011 Does anyone know what bearing will fit in these spindles? I have hunted high and low, but cannot find any info on the numbers on the old one. thanks! Share this post Link to post Share on other sites
TT-(Moderator) 1,162 #3 Posted March 7, 2011 What size / style is the deck? Share this post Link to post Share on other sites
mavfreak 11 #4 Posted March 7, 2011 can post a picture of deck? Share this post Link to post Share on other sites
KB9LOR 4 #5 Posted March 7, 2011 What size / style is the deck? 42 inch, old style hook up, steel spindle housings. Share this post Link to post Share on other sites
KB9LOR 4 #6 Posted March 7, 2011 can post a picture of deck? Will have to post one tomorrow... Share this post Link to post Share on other sites
KB9LOR 4 #7 Posted March 7, 2011 The pic below are of the deck and spindle, but be aware the deck had cast spindles NOT the steel ones I am replaceing the trashed cast ones with the steel ones. The original deck the steel spindles are off of are a pre-1973 Deck, that was on a 68 Raider 12. Share this post Link to post Share on other sites
racinfool40 203 #8 Posted March 7, 2011 Brian if it's a 1969 deck P/N 101480 for the top bearing from what I can tell and older decks use p/n 1515 they look the same to me?? and the bottom needle bearing is 1508..I hope this helps!! Share this post Link to post Share on other sites
KB9LOR 4 #9 Posted March 8, 2011 Brian if it's a 1969 deck P/N 101480 for the top bearing from what I can tell and older decks use p/n 1515 they look the same to me?? and the bottom needle bearing is 1508..I hope this helps!! Thanks! Now the 101480 is pretty steep, anyone know of a cheaper place to pick one up? cheapest I found is 18.72...... Share this post Link to post Share on other sites
TT-(Moderator) 1,162 #10 Posted March 8, 2011 101480 "crosses" to a 1603-2RS If that is what you actually have, dimensions should (approximately) be: 1.625" OD .750" ID .500" tall THIS should get you started in the right direction - or check with your local suppliers. :thumbs: Share this post Link to post Share on other sites
KB9LOR 4 #11 Posted March 8, 2011 101480 "crosses" to a 1603-2RS If that is what you actually have, dimensions should (approximately) be: 1.625" OD .750" ID .500" tall THIS should get you started in the right direction - or check with your local suppliers. Thanks TT! that is way more affordable! going to buy a few xtra! thanks again! Share this post Link to post Share on other sites
