C141 8 Speed

[dpm2000bolt 0]

What are the Drive Pulleys on the 8 Speed C141? I want to know if what I have is correct the Motor pulley is 4" and the axle pulley is 6 1/2". I have found the model number on the toro parts viewer and then that is what the toro dealer did as well but could not get the sizes of them.

I found a 310-8 with the drive pulley in a bone yard and snagged it figure it should be close, but is it?

[Kelly 1,033]

yes it is the same pulley, engine for a 8speed is 4" the trans. 6.5" sounds about right.

[dpm2000bolt 0]

Kelly... thank you as I am starting to feel good about it all now, needed confirmation on it. I put it all together tonight and was able to have the belt tight to where I mounted it before... needless to say when you dump the clutch she winds up and pulls the front tires Well it looks like I might be working on the PTO and hanging the snow blower on it as we are getting a bit of snow tonight. Diesel is looking pretty sweet in the power range!!!

[Duff 206]

I found a 310-8 with the drive pulley in a bone yard and snagged it .......

And you saved yourself a BUNCH of money - those aren't cheap!

~Duff :thumbs:

[dpm2000bolt 0]

Looking in the Bone Yard I was kicking around the Idea of putting a say 310 hood on the C141 to get the room so I would not have to cut my hood all up and leaving it in original condition. It look like all I would have to change is the Riser/Dash and the hood would this be wrong as it is now a diesel now

yeah I looked it up on a parts list the pulley that bolts on the axle shaft I got was listed for $40 I got a hitch and the bottom PTO angle plate off a B-80 I think all for $30 :thumbs: