dgjks6 6 #1 Posted January 22, 2011 I put the oil seals in the k181 last night. The rear - I assume the one by the flywheel, wet in to be about level In the manual, for the front (PTO) side, it said to set at 1/32", but for the flywheel/magneto system there was an asterisk that said it should seat on an inner lip, so I drove it in more. Noow it is about 3/32" in from the end. Take it out and start over, or is this correct? Share this post Link to post Share on other sites
Roger from southern Iowa 1 #2 Posted January 24, 2011 I've installed the seals to both depths without a problem. I would say the correct depth would be stated in the manual. :banghead: Share this post Link to post Share on other sites
