Engine Horse Power Decal

[MikesRJ 558]

Some of the earlier Kohler engines had the following decal along with the separate oval HP number decal mostly installed above this one. I know this decal was certainly on pre-1970 Kohlers.

I believe the year-break for the single decal was in the early 70's. It could have been right at 72 if memory serves.

I am also sure the '73 Kohler K241 used this decal with a 10 HP at the top.

[TT-(Moderator) 1,162]

How about a 1965 855/875 K-181 decal? (found on S/G belt guard):

K-141 "6hp" decal (1963 633 - sorry 'bout the flash reflection and the "over spray" ):

K-161 "7hp" decal (1963 753):

[MikesRJ 558]

It appears Kohler used the same "follow the book to the letter" way of production WH did ... :thumbs:

[Vinylguy 4,691]

WOW

I was hoping they all were alike

but it appears not. Hoping this will work for the older kohlers.

Feedback please.

[Vinylguy 4,691]

6 1/4 hp

[Kelly 1,033]

You know Terry your going to make me buy a bunch of these I've been looking for them for a while now. Thanks for the great work.

[HankB 16]

It's not clear if you got all of the samples you were looking for but I have a decent picture of the stickers on the K301 on my '85 312-8:

Let me know if you want me to measure the dimensions.

Thanks for your work in this area.

-hank

[MikesRJ 558]

Terry,

Since you're working on Kohler engine decals, how about these four? These are nearly impossible to find. I only wish I had better shots of the alternator three. Perhaps someone else has clearer shots of those.

[sorekiwi 761]

I only wish I had better shots of the alternator three.

Umm, Mike - thats a starter motor. Chuck will be along shortly to explain it all to you....

This one (measured from outside edge of border to outside edge of border) is 2 1/4" wide by 7/8" high.

This is 3 1/8" wide by 1 7/8" high

and this one is 2 5/8" wide by 1 3/8" high.

I can get better shots tomorrow in daylight if you need 'em Terry.

[Vinylguy 4,691]

I can work from those images and dimensions Mike

Will get to them as soon as possible. Looks to be a busy week but will try to do them before friday if possible. I would do them tomorrow but I have to be out of town.

Thanks again

[Anglo Traction 761]

Like Mike, I've been searching for the same Engine Decals.

Not wishing to prevent Terry from producing the Air Filter Instructions shown in Mike's photo, but RCPW list this Decal as an Authorised reproduction under the Kohler part# of 25 113 07-s.. for $1.39. ......no luck on the others.

I have to say for producing these so far. I'll be looking to place an Order for a few Sets for Tractor and Engine next month.