boovuc 1,090 #1 Posted May 16, 2010 Chuck, All, Thanks for your help on this project. I didn't post pictures until I was 100% sure I had good contacts everywhere. After tearing it down again and scrubbing the contacts on everything, I got power across the switch and the A terminal on the generator/starter. Some ether and a prayer, (plus a doush of the gass tank, lines and the pump), and it fired up. Boy does it need rings! Thanks for the help guys! BooVuc Mill Hall, PA Share this post Link to post Share on other sites
Kelly 1,028 #2 Posted May 18, 2010 Just a tip don't use ether in these small engines, most carb or break cleaners work fine and will not hurt the alum rods like ether does or can. Share this post Link to post Share on other sites
Save Old Iron 1,563 #3 Posted May 18, 2010 BooVuc, Good to hear. Don't underestimate the value of THOROUGHLY cleaning the wiring terminals and connections. We did OK on this one - no pics and just 1 post. Koool! Share this post Link to post Share on other sites