looking for some grader blade measurements

[876wheelhorse 46]

looking to try to make a grader blade. I have a old blade i bought that the bottom half is pretty rusty. figured cut it into and attempt to make a grader blade need to know the height of the blade also. thanks hopefully someone can help me out.

[DMK855 15]

Well, Being that is my blade in the pic, I will do my best to get you some measurements!!

I was going to build one too until I saw this one lurking on Bill Jenkins shelf in Dec.!!!

[DMK855 15]

A= 40" I am sure you can make it as wide as you would like!?!?

B= 22"

C= 6 1/8"

D= 2"

Note...... The sides of the main frame are 1 3/4" tall and the front and taper to 1" tall and the rear.

The blade is 7 1/4" tall.

E= see pics......

If I can help out with any more pics or measurements, let me know!!!

[TT-(Moderator) 1,162]

Here's some more good reading / ideas:

http://www.wheelhorseforum.com/index.php?act=ST&f=4&t=1285

[876wheelhorse 46]

thanks for the measurements i have been reading about all the topics on this gathering all the information i can. thanks again