Prater 75 #1 Posted November 23, 2009 After getting advice through PM's and on the board I decided to ditch a short frame novelty and go for a sturdier framed puller. I dug through the parts that I picked up a week or so ago and put together a good start... I have some wheels that will fit the 26x12-12 tires i plan to buy. I just have to do some fabrication to get the fenders to clear. Then I will figure out where to put the fuel... Keep the advice coming...I really appreciate it. Share this post Link to post Share on other sites
tgranthamfd 28 #2 Posted November 23, 2009 Cool haven't noticed to many Black hood pullers. :notworthy: Share this post Link to post Share on other sites
Save Old Iron 1,563 #3 Posted November 23, 2009 :notworthy: Share this post Link to post Share on other sites
KeithB 6 #4 Posted November 23, 2009 just use some 1" spaces under the rear fender. Share this post Link to post Share on other sites
Prater 75 #5 Posted November 23, 2009 Keith, Do you have any pictures of your weight bar off the tractor? Share this post Link to post Share on other sites
baerpath 517 #6 Posted November 24, 2009 Another way to lift the fenders is cut the H and weld in a section to raise them. As far as the gas tank I mount mine under the fenders inside the H Only need a small tank baerpath Share this post Link to post Share on other sites
gardentracotpullinfool 0 #7 Posted April 7, 2010 i removed my stock tank unbolted the stock mounts and now have 6x6 wheels under my horse. i used a tank from midwest super cub mounted inside the fender pan mount. Share this post Link to post Share on other sites
