702854boy 1,205 #1 Posted 17 hours ago Would anyone have any photos on how to add a lift assist spring to the snow blower on my 854? I tried searching but I haven't found any good photos. I also need the dimensions for the spring and all the hardware needed. Share this post Link to post Share on other sites
gwest_ca-(File Mod) 12,543 #2 Posted 16 hours ago 1 1 Share this post Link to post Share on other sites
ri702bill 13,323 #3 Posted 11 hours ago (edited) Gary beat me to it. I added one on the ST-324 mounted to my 854 - it works well. Adjustment is a fine balance of too little or too much though... I had to weld a bent tab to the Flag - I already had the spring. Bought the 3/8-16 eyebolt and a matching Nylok nut. The other end of the spring hooks over the 3/4" diameter rod welded to the frame for the foot rests & pedals. Lowell sells the repro flags & hardware... Edited 6 hours ago by ri702bill 1 Share this post Link to post Share on other sites
ML3 2,561 #4 Posted 9 hours ago Heres my spring I added on my 702 w/ST323 blower. Adjustment definitely takes some time but once dialed in it the spring makes a big improvement. (I have a very bad back) Also makes a big improvement when you disconnect the rear hitch lift cable if you have weights on hitch! Stupid me didn't even think of that at 1st whenever I was installing spring! 🙄 1 1 Share this post Link to post Share on other sites
squonk 48,358 #5 Posted 9 hours ago Make sure the lift flag is connected to the hole closest to the rock shaft centerline. 1 Share this post Link to post Share on other sites
peter lena 10,115 #6 Posted 7 hours ago @ML3 like that , another thing I regularly use is a TURNBUCKLE , lets you DIAL IN A SPRING ASSIST , LUBE AS YOU GO . do you have a dense rubber isolation pad , on that weight arm to bottom of rear end ? greatly reduces the pin point weight on a casting . pete Share this post Link to post Share on other sites
Handy Don 17,694 #7 Posted 6 hours ago 3 hours ago, ML3 said: How much weight is that!? Share this post Link to post Share on other sites
ML3 2,561 #8 Posted 4 hours ago 1 hour ago, Handy Don said: How much weight is that!? Only 50lbs. 3 hours ago, peter lena said: @ML3 like that , another thing I regularly use is a TURNBUCKLE , lets you DIAL IN A SPRING ASSIST , LUBE AS YOU GO . do you have a dense rubber isolation pad , on that weight arm to bottom of rear end ? greatly reduces the pin point weight on a casting . pete Its only 50lbs of weight on back. Its bolted thru a hitch flat drawbar 1 1 Share this post Link to post Share on other sites