Jump to content
702854boy

Shortframe Snowblower

Recommended Posts

702854boy

Would anyone have any photos on how to add a lift assist spring to the snow blower on my 854? I tried searching but I haven't found any good photos. I also need the dimensions for the spring and all the hardware needed.

Share this post


Link to post
Share on other sites
 
gwest_ca

 

  • Like 1
  • Thanks 1

Share this post


Link to post
Share on other sites
 
ri702bill

Gary beat me to it. I added one on the ST-324 mounted to my 854 - it works well. Adjustment is a fine balance of too little or too much though...

I had to weld a bent tab to the Flag - I already had the spring. Bought the 3/8-16 eyebolt and a matching Nylok nut. The other end of the spring hooks over the 3/4" diameter rod welded to the frame for the foot rests & pedals.

Lowell sells the repro flags & hardware...

Edited by ri702bill
  • Like 1

Share this post


Link to post
Share on other sites
 
ML3

Heres my spring I added on my 702 w/ST323 blower. Adjustment definitely takes some time but once dialed in it the spring makes a big improvement. (I have a very bad back) Also makes a big improvement when you disconnect the rear hitch lift cable if you have weights on hitch! Stupid me didn't even think of that at 1st whenever I was installing spring! 🙄 

20251209_182954.jpg

20260118_152516.jpg

  • Like 1
  • Excellent 1

Share this post


Link to post
Share on other sites
 
squonk

Make sure the lift flag is connected to the hole closest to the rock shaft centerline.

  • Like 1

Share this post


Link to post
Share on other sites
 
peter lena

@ML3  like that  , another  thing  I  regularly  use is a TURNBUCKLE , lets you   DIAL IN A SPRING   ASSIST , LUBE AS YOU GO . do you have a dense rubber isolation pad , on that  weight  arm to bottom of  rear end ? greatly reduces the pin point weight  on a casting . pete

Share this post


Link to post
Share on other sites
 
Handy Don
3 hours ago, ML3 said:

20260118_152516.jpg

How much weight is that!? :)

Share this post


Link to post
Share on other sites
 
ML3
1 hour ago, Handy Don said:

How much weight is that!? :)

Only 50lbs.

 

3 hours ago, peter lena said:

@ML3  like that  , another  thing  I  regularly  use is a TURNBUCKLE , lets you   DIAL IN A SPRING   ASSIST , LUBE AS YOU GO . do you have a dense rubber isolation pad , on that  weight  arm to bottom of  rear end ? greatly reduces the pin point weight  on a casting . pete

Its only 50lbs of weight on back. Its bolted thru a hitch flat drawbar

  • Like 1
  • Thanks 1

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...