Jump to content
702854boy

Shortframe Snowblower

Recommended Posts

702854boy

Would anyone have any photos on how to add a lift assist spring to the snow blower on my 854? I tried searching but I haven't found any good photos. I also need the dimensions for the spring and all the hardware needed.

Share this post


Link to post
Share on other sites
 
gwest_ca

 

  • Thanks 1

Share this post


Link to post
Share on other sites
 
ri702bill

Gary beat me to it. I added one on the ST-324 mounted to my 854 - it works well. Adjustment is a fine balance of too little or too much though...

I had to weld a bent tab to the Flag - I already had the spring. Bought the 3/8-16 eyebolt and a matching Nylok nut. The other end of the spring hooks over the 3/4" diameter rod welded to the frame for the foot rests & pedals.

Lowell sells the repro flage & hardware...

Edited by ri702bill

Share this post


Link to post
Share on other sites
 
ML3

Heres my spring I added on my 702 w/ST323 blower. Adjustment definitely takes some time but once dialed in it the spring makes a big improvement. (I have a very bad back) Also makes a big improvement when you disconnect the rear hitch lift cable if you have weights on hitch! Stupid me didn't even think of that at 1st whenever I was installing spring! 🙄 

20251209_182954.jpg

20260118_152516.jpg

  • Like 1

Share this post


Link to post
Share on other sites
 
squonk

Make sure the lift flag is connected to the hole closest to the rock shaft centerline.

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...