richmondred01 2,393 #1 Posted 13 hours ago I remember years ago something about warning light panels caused a grounding or a short causing the magnum engine failing to turn over. If I recall correctly pulling the circuit board resolved the issue. Does anyone recall? Share this post Link to post Share on other sites
gwest_ca-(File Mod) 12,540 #2 Posted 9 hours ago 3 hours ago, richmondred01 said: Does anyone recall? No. Share this post Link to post Share on other sites
953 nut 70,431 #3 Posted 22 minutes ago 12 hours ago, richmondred01 said: I remember years ago something about warning light panels caused a grounding or a short causing the magnum engine failing to turn over. If I recall correctly pulling the circuit board resolved the issue. Does anyone recall? I don't remember the thread and you didn't tell us the specific model you are dealing with. Not all Wheel Horses are wired alike but take a look at the wiring diagram for the model in question and you will find that the Seat switch, Oil Level switch, PTO switch, and Neutral switch all have additional wires that feed their respective indicator lights. If the wires of the PTO switch or the Neutral switch were grounded by the light panel by corrosion or a physical fault that might interfere with the starter solenoid by not allowing a relay to close. Search the manuals section for the model number wiring diagram, the ones attached ar examples and since you didn't tell us the model you are having problems with these may or may not be correct for your situation. Share this post Link to post Share on other sites