Jump to content
CCW

Mow deck spindle question

Recommended Posts

CCW

The 36 in RD mower deck on my 312-8 is nearly 40 years old.  It has always been garage and the shell is as solid as the day it was bought.  Over the past couple of years I have been adding grease via the zerks and all appears to work great though it is very loud while engaged.  

 

My concern is the grease at the bearings.  Does it dry out that new grease may not be reaching the bearings?  How do I know if I have added enough grease?  Or is this a case of if it ain't broke don't fix it?  I hate to disassemble the deck if there is no sure benefit.

 

 

Edited by CCW

Share this post


Link to post
Share on other sites
 
8ntruck

It is probably time to disassemble the spindles.  If you have noise that wasn't there in the past, something has changed - a bad bearing, a worn shaft, etc.  Check the spindles individually for smooth rotation, end play, and radial play.  That should give you a clue as to which one is the worst, therefore the one to start on.  Remember, all the spindles have been in service the same amount of time.  If one is bad, the others probably are reaching the end of their service life too.

 

I've got three decks that I need to have that done.

  • Like 2

Share this post


Link to post
Share on other sites
 
gwest_ca

If you remove the spindle belt and feel and spin each pulley you may find they don't feel or sound the same. A good first step in your inspection. Find a bad one then make the necessary repairs followed by another spin comparison. By now you will know what a good spindle assembly sounds like.

  • Like 1

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...