Jump to content
Cee245

Surprise! A 416-8 and a plan

Recommended Posts

 
953 nut

My favorite four letter word,                          FREE

  • Like 3
  • Haha 2

Share this post


Link to post
Share on other sites
 
ebinmaine

Nice gift! 

Share this post


Link to post
Share on other sites
 
702854boy

It looks like the mower belt might be in the wrong groove on the clutch bell.

  • Like 2

Share this post


Link to post
Share on other sites
 
Cee245

Good catch!  It sure is.  It's getting tossed along with most of the deck. It is pretty beat.  Several large rust holes.  Hopefully i can salvage a few things like spindles. 

Edited by Cee245

Share this post


Link to post
Share on other sites
 
Bill D
45 minutes ago, Cee245 said:

Good catch!  It sure is.  It's getting tossed along with most of the deck. It is pretty beat.  Several large rust holes.  Hopefully i can salvage a few things like spindles. 

I like to run decks like that until they are completely unusable.   Save the wear and tear on the good ones. 

  • Like 1

Share this post


Link to post
Share on other sites
 
rjg854

As long as decks work as they should and still give a nice cut, a good, experienced welder can take care of any holes.

  • Like 1

Share this post


Link to post
Share on other sites
 
Cee245

Thanks...  for me, thats the issue.  No welder amd limited experience.  You're right though,  it just is ugly.  No reason I can't grease and oil it to keep it solid for longer and just cut grass! 

 

I Found out that I am 2nd owner.  I've gone over it a bit and to my surprise, it's actually in pretty decent shape overall. Even seat switch works! All original tires hold air and have the wear id expect for hrs shown. The meter says 527 or so and it appears to be accurate. Just left outside under a lean to.

 

From what I've seen the 6" tires seem to get bald by 800 hrs. The 8" generally have ok tread at 1000 hrs/use. 

 

I set valve clearances.  Popped off flywheel and cleaned. Need to decarbon heads and find a new ignition switch.   I dont know how this actually works with all the corrosion.  

 

The engine shroud had the obligatory mouse nest for a low cost machine lol. 

 

Ordered full gasket set and will need a few other things as I have time to work on it.  

 

 

20261115_211250.jpg

 

20261115_212910.jpg

 

264d6e3a-060f-474c-a383-6ce42c43f152.jpg

 

Edited by Cee245
Spaced pictures apart
  • Excellent 1

Share this post


Link to post
Share on other sites
 
ebinmaine
2 hours ago, Cee245 said:

Ordered full gasket set and will need a few other things as I have time to work on it.  

 

Great to see it getting the maintenance deserved! 

 

 

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...