Darek 0 #1 Posted 5 hours ago Need some assistance please! I am trying to replace these pulleys pictured and what happening is once they and the two spacers are put on the shaft there are not enough threads left to put the shroud and nut back on. It looks to me like part of the race from the V pulley is still on the shaft thus taking up space causing my issue. The race is possibly fused to it as it almost looks like its supposed to be that way. What would be the best way to rectify this? TIA. Share this post Link to post Share on other sites
nylyon-(Admin) 9,056 #2 Posted 5 hours ago You are correct that race should not be there, may need to cut it and split it to get it off 2 Share this post Link to post Share on other sites
ri702bill 12,994 #3 Posted 4 hours ago 51 minutes ago, nylyon said: You are correct that race should not be there, may need to cut it and split it to get it off Or, you may get lucky by heating the race and then attrmpting tp remove it with proper sized Vise Grips. A small amount of penetratiog oil on the shaft helps, but keep it away from the area where you grip it. Share this post Link to post Share on other sites
