CRF857 1,144 #1 Posted October 4 There is a Toro dealer about twenty miles from me. On Monday I was going to be within ten miles of it and made the side trip there. Asked if they had any clunkers out back they wanted to get rid of. I didn’t need a runner, didn’t care about engines or hydros. The two owners just stared at me for a few seconds, then said follow us. Showed me a Toro Time Cutter 4235. No engine. Said they had just unloaded it 5 minutes before I got there. $20 and ten minutes later it was in the back of my truck. Took it home and stripped it. Talked to the owner of the local mower repair shop. He took the hydros, wiring harness, rear bumper and rear shield, and the two struts. Wouldn’t take anything for it since he takes care of me with parts and mowers. Went through my steel and came up with enough to fab a rear axle and tongue. Got done and gave it a test drive just before the rain came. Clean up and paint next. Then decide if it will be a flat bed/hay rack or put sides on it and make a wagon. Thing is I don’t need any of those. Just wanted to make something. 4 7 Share this post Link to post Share on other sites
ebinmaine 80,755 #2 Posted October 4 4 minutes ago, CRF857 said: Then decide if it will be a A. flat bed B. hay rack C. put sides on it D. make a wagon E. All of the above. 2 1 Share this post Link to post Share on other sites
CRF857 1,144 #3 Posted October 4 (edited) 8 minutes ago, ebinmaine said: E. All of the above. Why of course! 😃 May have access to some used metal roofing/siding. Depends on pricing. Edited October 4 by CRF857 1 1 Share this post Link to post Share on other sites
Handy Don 17,484 #4 Posted October 4 That’d also make a dandy show trailer with room for the CFO and acquisitions! 1 1 Share this post Link to post Share on other sites
CRF857 1,144 #6 Posted Friday at 10:27 PM (edited) Did some work on the wagon yesterday and today. Made a framework high enough to clear the rear tires. Got all the welding and grinding done yesterday. Today was cleaning and painting. The only paint colors I had enough of were orange and blue. Two different oranges. The lighter orange was close to University of Tennessee orange. I used it on the bottom of the chassis and both sides of the bed. The other orange and the blue are University of Illinois colors. That orange was used for the top of everything except the bed and framework for the bed. The bed framework and wheels are blue. I will probably put wood sides on it at some point. Any other pieces for maybe bed sides will be blue and or stained wood . The last two pictures show the difference in the two oranges. Edited Friday at 10:29 PM by CRF857 5 3 Share this post Link to post Share on other sites
CRF857 1,144 #7 Posted 2 hours ago Spent a few days gathering parts and painting. Put three coats of paint on the wood. Went out this morning and assembled it. Took it out front and did a photo op in front of the Halloween decorations. Used the matching Roper to move it. The wife threw in some deadheaded flowers to take to the compost while it was there. So it has already been put to work. 4 Share this post Link to post Share on other sites