CRF857 952 #1 Posted 2 hours ago There is a Toro dealer about twenty miles from me. On Monday I was going to be within ten miles of it and made the side trip there. Asked if they had any clunkers out back they wanted to get rid of. I didn’t need a runner, didn’t care about engines or hydros. The two owners just stared at me for a few seconds, then said follow us. Showed me a Toro Time Cutter 4235. No engine. Said they had just unloaded it 5 minutes before I got there. $20 and ten minutes later it was in the back of my truck. Took it home and stripped it. Talked to the owner of the local mower repair shop. He took the hydros, wiring harness, rear bumper and rear shield, and the two struts. Wouldn’t take anything for it since he takes care of me with parts and mowers. Went through my steel and came up with enough to fab a rear axle and tongue. Got done and gave it a test drive just before the rain came. Clean up and paint next. Then decide if it will be a flat bed/hay rack or put sides on it and make a wagon. Thing is I don’t need any of those. Just wanted to make something. 2 3 Share this post Link to post Share on other sites
ebinmaine 80,628 #2 Posted 2 hours ago 4 minutes ago, CRF857 said: Then decide if it will be a A. flat bed B. hay rack C. put sides on it D. make a wagon E. All of the above. 1 1 Share this post Link to post Share on other sites
CRF857 952 #3 Posted 2 hours ago (edited) 8 minutes ago, ebinmaine said: E. All of the above. Why of course! 😃 May have access to some used metal roofing/siding. Depends on pricing. Edited 2 hours ago by CRF857 1 1 Share this post Link to post Share on other sites
