TC10284 114 #1 Posted 9 hours ago 42in side discharge deck on a 312-8. Since I've had it, I haven't been able to get grease in the spindles. Tonight I took off the nut and lock washer, and the pulley off each spindle. I cleared out the holes in the shaft so grease could flow. I confirmed they were flowing by using my grease gun while the shaft was still out if the spindle. It did flow. I put the shaft back on the spindle, put the lock washer and nut back on. Tightened it down with the air impact and NOT MUCH! After tightening it down with the impact some, and testing to see if I could get grease to flow, it does not. Now it is coming out of the gap in the lock washer on top and I am at a loss. Pictures here: https://photos.app.goo.gl/oAhXNES35WiF1kT36 Share this post Link to post Share on other sites
gwest_ca-(File Mod) 12,343 #2 Posted 5 hours ago Does this apply to yours? Share this post Link to post Share on other sites
