deck bracket bushing and e clip?

[horseman with no horse 67]

i guess my e clip popped out the deck lift  in the frame, that and the bushing is gone, where can i get a replacement?

[horseman with no horse 67]

[horseman with no horse 67]

its the bushing and clip for this 

[gwest_ca-(File Mod) 12,324]

Toro at the bottom of the page

https://www.partstree.com/models/31-12k801-312-8-toro-garden-tractor-1990/hydrostatic-lift-linkage-312-h-416-h-9/

[Lee1977 7,694]

It's a 1/2" ID x 5/8" OD brass flange bushing. If you have hardware or Lowes or Home Depot that keeps there parts draw up tp date. it should not be hard to find

[ri702bill 12,401]

4 hours ago, Lee1977 said:

Lowes or Home Depot that keeps there parts draw up tp date

Not around here!! The local Lowes fasteners section is an absolute joke. The drawers resemble a campsite after being raided by a bunch of feral rabid raccoons.

And the local Home Depot "streamlined" their selection to about half the size it was 2 years ago.... marketing genius I guess.

[gwest_ca-(File Mod) 12,324]

The 1/2" E-ring will fit a 7/16" groove in a 1/2" shaft.

The rings are stamped so one side has rounded edges and the other is sharp. Install the ring with the sharp side facing away from the bushing for more holding pressure. The sharp edges have less chance of being forced out of the groove.

 

Correction - I had it backwards - fixed it.

[Ed Kennell 46,474]

My ACE Hardware has flanged bushings and E clips in the pull out drawers.

Edited 4 hours ago by Ed Kennell

[Blaine 165]

ACE is the place. 

[Brockport Bill 2,409]

i actually had the flange part of the hoodstand wear off and had to replace the hoodstand - - worse was the shaft itself was "rust welded" --- nightmare to get apart and remove