eric8 6 #1 Posted 3 hours ago Decided to take a look at the PTO pulley today and discovered there was no friction material visible when viewing the air gap between the pulley and clutch disc. Pulled it off, and sure enough, I was right. She’s toast. Couple of questions: 1. Part # 40 in the diagram, identified as the bearing race, will not slide off of the engine shaft. It appears fused on and won’t budge. Is this normal? 2. Part # 39 is supposed to be a bearing seal. Is it installed currently? I’m not seeing any kind of lip that a traditional bearing seal would have. Share this post Link to post Share on other sites
pfrederi 20,727 #2 Posted 2 hours ago You have to remove the 4 bolts and 2 small plates then number 40 will come off To me looks like seal 39 is there the rubber part may be worn away Share this post Link to post Share on other sites
