jsp_333 288 #1 Posted 2 hours ago I was researching snowblower stuff on the site yesterday and believe I saw a comment about "tensioning the lift assist spring too much" Is that a real thing? Could that keep the snowblower from sitting flush to an asphalt driveway? I tighten the nut to the very end of the thread. Share this post Link to post Share on other sites
ebinmaine 77,837 #2 Posted 2 hours ago What kind of snow blower and what model or type of tractor? Share this post Link to post Share on other sites
WHX?? 55,735 #3 Posted 1 hour ago Guessing a single with manual lift. I don't think you could tighten it enough to make it lift off the payment but it may bounce or skip over high spots? Share this post Link to post Share on other sites
jsp_333 288 #4 Posted 56 minutes ago Sorry. 79360 single stage on a 414-8. manual lift. Share this post Link to post Share on other sites
ri702bill 11,550 #5 Posted 8 minutes ago Yup, it is a tap dance to adjust. Not enough, it is hard to lift. Too much and the blower becomes too light to work correctly.... Share this post Link to post Share on other sites
