ri702bill 11,404 #1 Posted 4 hours ago (edited) The C81 I picked up last summer had a common crack issue on one side at the back end of the Hoodstand where the Z shaped bracket, rear fenderpan and seat hinges bolt on. So didn't my parts donor tractor, but on the opposite side.... Looking down on the Hoodstand it is a 3 piece spot welded construction shaped like the letter "H". The solution was to split the left panel welds and do a mix-n-match of the better parts, reinforce those corners, and reassemble with pop rivets. I used 1/8" x 1-1/2" angle iron cut to shape and drilled for four plug welds each. This was easy to do with it split apart.... almost impossible to do together... I used the original hole for a nut & bolt and 2 pair of locking pliers for the fixturing. Edited 32 minutes ago by ri702bill 2 6 Share this post Link to post Share on other sites
