2026 Big Show Buy/Sell/Trade Thread

[Handy Don 16,678]

Folding aluminum ramps. $90 ($75 to supporter member)

The arch in the upper end keeps the mower deck from catching as the tractor reaches the trailer bed.

 

 

 

 

[cafoose 3,733]

Looking for a 5060 or a 5071 6-speed to swap into my 953 sickle tractor. Can't make it to the show. If @sqrlgtr is going maybe I can con him into bringing it back for me 

[pfrederi 20,609]

Modified seat adjusters  They slide freely.  The holes in the spring to mount to the tractor are 7" OC....The holes on the sliders to mount the seat are 11-1/2 oc.

 

$10

 

 

[Ed Kennell 46,131]

17 hours ago, Blaine said:

 . So if one of the welded ones are about 16” from the flat of the bore area on the toothed side of the sector to the other end of the shaft, i should be able to make it work. 

The two welded shafts measure 20"  end to end and 15.6" between the welded parts.

[702854boy 803]

Would anyone have the pieces that go under the gas tank and dash thing on the 60s square hoods?

[Handy Don 16,678]

3 hours ago, pfrederi said:

Modified seat adjusters  They slide freely.  The holes in the spring to mount to the tractor are 7" OC....The holes on the sliders to mount the seat are 11-1/2 oc.

 

$10

I'll take these, please. What is the range of travel on the locking slide?

[Blaine 6]

3 hours ago, Ed Kennell said:

The two welded shafts measure 20"  end to end and 15.6" between the welded parts.

Excellent. Will you be at the big show on Thurday?

[Easton Rich 1,238]

1 hour ago, 702854boy said:

Would anyone have the pieces that go under the gas tank and dash thing on the 60s square hoods?

What pieces are you wanting?