JimSraj 561 #1 Posted Thursday at 06:18 PM (edited) Does anyone know the thickness & width of the reversible scraper on 36” snow blower? 06-42st 04 Edited Thursday at 06:20 PM by JimSraj Share this post Link to post Share on other sites
pfrederi 19,589 #2 Posted Friday at 12:40 AM Just switched one on a blower 1/8" steel i guess 2" width?? Share this post Link to post Share on other sites
Achto 30,630 #3 Posted Friday at 12:41 AM (edited) Not sure on the blowers. The wear blade on my plow is 1/4" thick by 2 1/2" wide. I make my new wear bars 3" wide in order to get a little more time out of them. Edited Friday at 12:42 AM by Achto 1 Share this post Link to post Share on other sites
JimSraj 561 #4 Posted Friday at 02:21 AM 1 hour ago, pfrederi said: Just switched one on a blower 1/8" steel i guess 2" width?? Thanks. I’ve got some 10 g sheet so I guess I’ll use that. I’ve seen everything from 1/8” to 1/2” on the web. Share this post Link to post Share on other sites
JimSraj 561 #5 Posted 4 hours ago FYI. So, as you may know, the scraper is reversible. When I removed the old one I was able to flip it around and use the other edge. In doing that I got accurate dimensions as follows: 3/16”(7 gauge) x 2” x 34-1/4” There’ s your dinner! Share this post Link to post Share on other sites
