CNC 10 #1 Posted 5 hours ago I have been using the horse for the last 3 or 4 months everything worked fine until a few days ago. I stared it up pulled it outside it started as usual, when I went back a few hours later it would not start ( engine would not turn over,no noise from solenoid nothing). I push the dead horse back into the garage and changed out the solenoid and battery from my other wheel horse ranger. Still nothing so I said must be the 2 safety switches. Pulled them off one of the brake switch wires was broken ( that must be the problem!) clean both switches and replaced with new wires. I reinstall everything still nothing. No noise engine will not turn over. Can anyone give me some suggestions on what to do next. I hope the ole c160 horse is not ready for the pasture Share this post Link to post Share on other sites
gwest_ca-(File Mod) 11,770 #2 Posted 5 hours ago Follow the red wire from the ignition switch to the starter solenoid. It should have power with the ignition switch in the START position. 1 Share this post Link to post Share on other sites
CNC 10 #3 Posted 5 hours ago Many thanks gwest-ca I will check that out Friday when i get back into the shop Share this post Link to post Share on other sites
squonk 44,706 #4 Posted 4 hours ago Everything goes thru the ammeter first. If this was mine that would be the first thing I check. Seen it many times. 2 Share this post Link to post Share on other sites
CNC 10 #5 Posted 1 hour ago Many thanks gwest-ca I will check that out Friday when i get back into the shop You know Squonk I don't know if I wired the ammeter. The glass is broken and it has no needle need to check that! Thanks Share this post Link to post Share on other sites
kpinnc 15,849 #6 Posted 17 minutes ago 5 hours ago, CNC said: I hope the ole c160 horse is not ready for the pasture If it is, I live an hour away and have a big pasture... Share this post Link to post Share on other sites
