WH 1075 - Key switch

[Phan 32]

Hello - I picked up 1075 recentlly with no key. I have tried with all keys that used for 865 and C, B, and 300 series, but it cannot ne inserted. 

Looking at the manual - it said the swich 4988. Anyone knows and where I can get the key.  

Thanks

 

 

[gwest_ca-(File Mod) 11,667]

Did you see these pictures? Click on the switch.

 

[953 nut 61,677]

5 hours ago, Phan said:

Hello - I picked up 1075 recentlly with no key. I have tried with all keys that used for 865 and C, B, and 300 series, but it cannot ne inserted. 

Looking at the manual - it said the swich 4988. Anyone knows and where I can get the key.  

Thanks

 

 

Is the switch the factory original or could it have been replaced by a previous owner the past six decades? If it looks like the one shown in the manual Gary put up and the regular mower key won't fit it may be a Snoopy Key. Tractor Supply or a John Deere dealer may have some.

 

Edited Thursday at 11:21 PM by 953 nut
fat finger

[Achto 29,674]

Cole Hersee key.

 

https://www.amazon.com/R30074-B17575-Ignition-Ferguson-Terramite/dp/B07NRS68MT/ref=sr_1_4

[Phan 32]

Hello All!

Thank you! The switch has been replaced. I found it in the amazon is matching the switch on the tractor. I ordered it and will arrive tomorrow. https://www.amazon.ca/dp/B093PDJRSF?

ref=ppx_yo2ov_dt_b_fed_asin_title

But the engine cease - cannot turn by hand. 

[953 nut 61,677]

The switch you have purchased is intended to operate with a solenoid. It is only rated at 30 amps and your starter will draw about 50 amps. Do you have a solenoid?

[Retired Wrencher 5,988]

Richard is correct. If you want to bring it back to original I just pick up an original type key from wheel horse parts and more.com. This is this switch works with the start GEN tractors. I hope everything works out. Just take your time.

[Phan 32]

4 hours ago, 953 nut said:

The switch you have purchased is intended to operate with a solenoid. It is only rated at 30 amps and your starter will draw about 50 amps. Do you have a solenoid?

No selenoid. 

[Phan 32]

4 hours ago, Retired Wrencher said:

Richard is correct. If you want to bring it back to original I just pick up an original type key from wheel horse parts and more.com. This is this switch works with the start GEN tractors. I hope everything works out. Just take your time.

I will consider it. I hope I can crang the engine - it seiges now.  

[Phan 32]

Dear All,

I fount a great post / discussion / comments on 1075 - it teaches me a lot.

 

[Retired Wrencher 5,988]

Give it a good look take notes and I think things will turn ok. Don’t be afraid to ask questions as you go.

Edited 4 hours ago by Retired Wrencher