BurtB 106 #26 Posted October 31 Okay, had some time to work on this. Have opened and inspected most of the valves, they look pretty good. One of the shafts has wear from a spring, I'll get pictures later. Orings are hard, as expected. The forward/reverse valve control housing 1/4-20 screws are not SHCS, they are 12 point splines. Pics attached. Anybody know offhand what socket I need? Share this post Link to post Share on other sites
702854boy 262 #27 Posted November 1 31 minutes ago, BurtB said: Anybody know offhand what socket I need? 3/8 or 7/16 12 point socket? Share this post Link to post Share on other sites
BurtB 106 #28 Posted November 1 Probably 3/8 or smaller. Duh. I was going through all my oddball spline/torx sockets looking for something that would fit the spline. I avoid 12pt sockets out of habit. Maybe I should just use a 12pt socket... Share this post Link to post Share on other sites
953 nut 62,223 #29 Posted November 1 A 12 point deep socket was needed, had to go buy one because none of my sets had one. 2 Share this post Link to post Share on other sites
pfrederi 18,978 #30 Posted November 1 1/4" 12 pt (1/4"drive works best as sockets are thinner_ 1 Share this post Link to post Share on other sites
