1966 856 clutch pulley cost ?

[FLtractor 62]

Wondering how much a new one of these middle pulleys would cost to replace… i can hear the bearing so eventually it will need replacing. Unable to locate the part number in the online manual I’ve looked on here. 

[8ntruck 8,157]

Some folks have removed the rivets holding the halves of the pulley together, removed the bad bearing, replaced it and bolted the pulley back together.

 

Wheel Horse used standard parts whenever they could.  Makes them easier to keep going some 60 years later.

 

Somebody will be along soon with more details.

[stvski80085 278]

It looks like an idler pulley to me.  Don’t hold me to it though. Same as a lot of drive belt idlers.

Edited April 11 by stvski80085

[Blasterdad 3,044]

Part #71 IPL

Pulley #1623

 

[Blasterdad 3,044]

https://wheelhorsepartsandmore.com/product/toro-wheel-horse-1623-1616-92-7102-pulley/

[FLtractor 62]

2 hours ago, Blasterdad said:

https://wheelhorsepartsandmore.com/product/toro-wheel-horse-1623-1616-92-7102-pulley/

Does it make a difference with the one on my tractor having the rivets on outside compared to the one you sent me in the link? Same pulley? 

[squonk 44,636]

 I messaged Brian at K & B about reproducing these and this is what he came up with.

 

 

@76c12091520h  

 

 

 

[Blasterdad 3,044]

6 hours ago, FLtractor said:

Does it make a difference with the one on my tractor having the rivets on outside compared to the one you sent me in the link? Same pulley? 

 

Shouldn't make any difference. I like the looks of K & B's pulley, looks like a better quality, both should work fine though. 

[peter lena 9,459]

@FLtractor  if you use the original  type , looks like you have the wide rubber side grease shields , OPORTUNITY  IS THE WORD , very small flat putty knife  or flat pocket screwdriver , carefully remove side shields , wipe out  original " lubricant " carb cleaner flush out go lucas green  hd  chassis grease . polyurea rated , 550 flash point , change that  into a smooth / quiet  set up , only a suggestion , pete 

[FLtractor 62]

3 hours ago, squonk said:

 I messaged Brian at K & B about reproducing these and this is what he came up with.

 

 

@76c12091520h  

 

 

 

Thank you