Marv 979 #1 Posted June 21, 2024 I remember something about drilling a hole in the pin. What was that all about. My memory is VERY fuzzy lately. Marv Share this post Link to post Share on other sites
tunahead72 2,543 #2 Posted June 21, 2024 Probably to install a cotter pin and washer(s) to keep the lift pin from banging into the center spindle grease fitting. I know the subject has come up recently, looking for a good thread now, but my memory is a bit fuzzy these days too, could take a while. Share this post Link to post Share on other sites
tunahead72 2,543 #3 Posted June 21, 2024 See if this helps. There's a link in there to another thread that might also be useful. Center spindle grease zerk sheared off - Implements and Attachments - RedSquare Wheel Horse Forum Share this post Link to post Share on other sites
