Got the 857 assembled this morning, the choke cable is frozen and is getting a WD40 treatment and I need to sort the wiring out... I should have taken pics of what wiring went where when I was pulling it apart, but I was in a hurry to get it in the truck! I'm undecided weather I should trim the floor board to fit the PTO controls, or just remove them. Most likely there won't be any mowing or tilling with it, just pulling stuff with the hitch. I tried some WD40 and 180 grit on the hood to see if it would clean up and it seemed to work pretty good! I cleaned up the mess with SD-20 degreaser and some blue rags. The fuel pump is missing the fittings and lines so I'll have to IV-drip some fuel into the carb when it's time to test start it... then I'll see what I can wrangle up to get the pump working like it should.