Leaderboard

Put a bigger deck on your older short wheel base tractor 1054-1270. Deck shell is solid. Can bring to the big show. Adjusted price to what it cost me not looking for profit.

SOLD! SOLD! Thank you! 2012 copyright “Straight from the Horses Mouth” Book and DVD. I have sold all my WheelHorse tractors and just ran across this book. It is in new condition, just as it was shipped to me. 251 pages. $40 OBO.

I am looking for an Original Suburban 401 or 701 choke cable for my 401

Wheel horse 42" Rear Discharge Mower Deck....Very Nice Condition...Nice Mule Drive and Belt Included....No Blades. 240.00

SOLD ; This Deck in in Like New (Original) Condition , and was removed from my 312-8 back when tractor was 1st purchased to install a side discharge - bagger system . No issues , you'd be hard presses to find 1 nicer , unless you found a NOS unit @ a dealer ! No disappointments. Note ; The factory (Mule Drive) is also Included , but is missing (1) pulley !

For Sale: 2002 Wheel Horse 314-8 Tractor * Only 236 hours * 14 Hp kohler * Reliable 8-speed cast iron rear end * 48” Reinforced side discharge mower deck * Well maintained — everything works as it should * New rear tires recently installed This is a solid, dependable tractor built to last — the kind you buy once and keep for years. 💲 Price: $2,850 📞 860_681_3610 📍 Location: Southington, Connecticut Can be delivered to PA show IMG_8110.mov

I may be retiring from building engines unless I can find a crank grinder. Therefore, I’ve rebuilt several engines in anticipation of his retirement and have been holding on to them. I have complete two complete drop in ready K341 wheel horse spec engines (one is a 13 fin). One drop in ready wheel horse spec k321 and one k321 long block plus the pan, head valve breather assembly. All engines have been torn down to the bare block cleaned and Bored .010 over, crank ground .010, valve seats ground, head decked, rebuilt or new carburetors, new piston, rings, rod, valves, guides, seals and gaskets, air filters, plugs, fuel pumps, points and condensers Located in Mechanicsville, VA. Prices start at 800.00 no core required. Photos of the rebuild are available if requested. Any questions contact me via PM.