Leaderboard

Just send mail costs & I'll send them out. I have 1974 B-80, 1975 B-80, 1978 B-81 / B-111, 300 & 400 Series Manual, & operating instructions for Dozer/Snow Blade 42" & 48" blades.

I have too many projects, so here is an 875 roller. The PO added a hydro lift to the original Wheelamatic. The lift and the hydro drive work...however I am not sure putting a hydro lift on was a good idea, lifts were not an option on Wheelamatics. . I can't figure out where there would be an implement relief valve. The hose to the front of the cylinder leaks badly but the cylinder itself and control valve seem good. There is a hood but it was cut to clear a B&S engine. Steering is very sloppy and motion control needs work one rear tubeless tire goes soft. The engine is NOT included, put it on to test the hydro. I can't bring it to the show (not enough room in my truck and I can't pack like pullstart😀). However, if you live in the Northeast and are going to/from the show, I am 3 miles off I-81 (exit 211) north of Scranton

42" SNOW PLOW & FRAME (2) NO REAR MOUNTING BRAKET / HARDWARE, ALSO MISSING BLADE ANGLE ADJUSTMENT HANDLES NOTE: The “A” style is for short frame mid-to-late 60’s tractors, mounts ahead of the axle housing. The parallel frame is for long frame tractors from the 70’s onward, mounts under the rear axle PRICE LISTED IS FOR EVERYTHING, NOT EACH

This is a project. No electrical hooked up, no fuel lines hooked up. Kohler 10hp replacing the original engine. I got it this way and had plans on completing it and realize I won't be. Also extra set of rear rims. Someone save it please.