Leaderboard

These are my last four engines (the two 16’s have been sold) One drop in ready wheel horse spec k321 and one k321 long block plus the pan, head valve breather assembly. All engines have been torn down to the bare block cleaned and Bored .010 over, crank ground .010, valve seats ground, head decked, rebuilt or new carburetors, new piston, rings, rod, valves, guides, seals and gaskets, air filters, plugs, fuel pumps, points and condensers Located in Mechanicsville, VA. Prices start at 800.00 no core required. Photos of the rebuild are available if requested. Any questions contact me via PM.

I have a front cutter bar for sale. Will bring to the show if paid for prior. Very good shape and works as it should.

Re-priced for quick sale... Any interest in 60" finish mower for a D series. Bought it years ago went over it new seals a couple new bearings belt etc, But my D would over heat the tranny. So I put it under a bench. By the time I overhauled the D200 hydro I had gotten a finish mower for my Case VAC so this deck has sat for many years in the shop. It is complete with PTO shaft and coupler and leveling chains. There is a small piece of side guard missing. Flat steel would be easy to fabricate. Didn't really affect mowing performance. Can bring to the big show.