chev0545 231 #1 Posted February 26, 2017 (edited) I can't get the jerk out of the hydro.been adjusting the plate nut still jerky.on a 96 416 thanks Edited February 26, 2017 by chev0545 Share this post Link to post Share on other sites
can whlvr 991 #2 Posted February 26, 2017 probally got some worn parts,dont know what model but it sounds like an eaton setup,check the entire likage over Share this post Link to post Share on other sites
pfrederi 17,147 #3 Posted February 26, 2017 Model # of tractor would yield better help. Share this post Link to post Share on other sites
Cee245 754 #4 Posted February 26, 2017 (edited) The tractor model number for a 97 416h is 73423. The 96 model is the same. Not sure of tranny model number. C Edited February 26, 2017 by cee245 Share this post Link to post Share on other sites
can whlvr 991 #5 Posted February 26, 2017 it will be an eaton 1100 setup,as mentioned start looking for slop in linkage Share this post Link to post Share on other sites
illinilefttackle 399 #6 Posted February 26, 2017 When was oil changed last & what brand Filter is on it? Al 1 Share this post Link to post Share on other sites
chev0545 231 #7 Posted February 26, 2017 just changed oil & stens filter.i'm going to try a new plate & friction washers Share this post Link to post Share on other sites
